Latest H12-811_V1.0 Exam Real Tests Free Updated Today
H12-811_V1.0 Real Exam Question Answers Updated [Nov 05, 2023]
NEW QUESTION # 328
An ACL is essentially a packet filter. Only when the ACL is applied to the service module can the ACL take effect.
- A. False
- B. True
Answer: B
NEW QUESTION # 329
When using FTP for file transfer, how many TCP connections will be established?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION # 330
What is wrong about the description of the information as shown in the figure? () (Single-choice question) (RI) display interface g0/0/0 GlgabltEtherneto/0/0 current state :Adainistratively DOWN Line protocol current state :DOWN
- A. GigbitEthernet (0/0/0 interface does not enable dynamic routing protocol
- B. GigbitEthernet (/0/0 interface is connected to a wrong cable
- C. The GigbitEthernet0/0/0 interface is not configured with an IP address
- D. The GigbitEthernet0/0/0 interface was manually closed by the administrator
Answer: D
NEW QUESTION # 331
Which field in the IPv6 header is similar to the TTL field in the IPv4 header?
- A. Version
- B. Hop Limit
- C. Traffic Class
- D. Next Header
Answer: B
NEW QUESTION # 332
The administrator finds that the two routers stay in the 2-WAY state when establishing OSP neighbors, then the following description is correct ().
- A. The router is configured with the same area ID
- B. These two routers are DR0ther routers in the broadcast network
- C. The router is configured with the wrong Router ID
- D. The router is configured with the same process ID
Answer: B
NEW QUESTION # 333
When the lease period reaches what percentage does the DHCP client send the lease renewal message for the first time? ()
- A. 0.25
- B. 0
- C. 0.5
- D. 0.875
Answer: C
NEW QUESTION # 334
For multiple paths to the same destination network, the router needs to select by comparing the magnitude of the Prererence value. If the Preference is the same, the router selects according to the magnitude of the Cost value. ()
- A. False
- B. True
Answer: B
NEW QUESTION # 335
In the OSPF protocol, which of the following descriptions of DR is correct? ()
- A. If the priority values of the two routers are equal, the router with the larger Router ID is selected as the DR
- B. If the priority values of the two routers are different, the router with the lower priority is selected as the DR
- C. DThe adjacency relationship should also be established between R and BDR
- D. By default, all routers in this broadcast network will participate in the DR election
Answer: C
NEW QUESTION # 336
AP does not need AC. It can independently complete the work of wireless user access, wireless user authentication, and business data forwarding.
- A. True
- B. False
Answer: B
NEW QUESTION # 337
The Router ID of OSPF must be the same as the IP address of a certain interface of the router.
- A. True
- B. False
Answer: B
NEW QUESTION # 338
What is the total length of the VLAN frame format defined by IEEE802.1Q? ()
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION # 339
Which bridge ID is unlikely to appear in the configuration BPDU sent by the switch?
- A. 0 00-01-02-03-04-CC
- B. 4096 00-01-02-03-04-CC
- C. 8192 00-01-02-03-04-CC
- D. 2048 00-01-02-03-04-CC
Answer: D
NEW QUESTION # 340
When we search for accessible wireless networks on our laptop, what is the actual network name displayed?
- A. BSSID
- B. ESS
- C. SSID
- D. BSS
Answer: C
NEW QUESTION # 341
When OSPF protocol establishes adjacency, which of the following parameters must be consistent.
- A. Area ID
- B. Router Priority
- C. Router Dead Interval
- D. Router ID
Answer: A,C
NEW QUESTION # 342
The topology shown in the figure and the configuration on the interconnection ports of the switch. Can it be judged that the data frame tagged as VLAN10 can be forwarded normally between the two switches? ()(True or False)
(LSW1) interface GigabitEthernet 0/0/1
(LSW1-GigabitEthernet0/0/1) port link-type trunk
(LSW1-GigabitEthernet0/0/1) port trunk pvid vlan 20
(LSW1-GigabitEthernet0/0/1) port trunk allow-passvlan 10
#
(LSW2) interface GigabitEthernet 0/0/1
(LSW2-GigabitEthernet0/0/1) port link-type trunk
(LSW2-GigabitEthernet0/0/1 port trunk pvid vlan 10
(LSW2-GigabitEthernet0/0/1) port trunk allow-passvlan 10
- A. False
- B. True
Answer: B
NEW QUESTION # 343
As shown in the figure below. Host A and Host B cannot communicate. ()(True or False)
- A. True
- B. False
Answer: B
NEW QUESTION # 344
As shown in the figure, host A and host B want to implement inter-VLAN communication through single-arm routing. What configuration should be done under the G0/0/1.1 interface of RTA?()(Single-choice question)
- A. dotlq termination vid 30
- B. dotlg termination vid 1
- C. dotlq termination vid 20
- D. dotlq termination vid 10
Answer: D
NEW QUESTION # 345
The configuration information of a certain port of the switch is shown in the figure. What is the PVID of this port? () (Single-choice question)
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION # 346
As shown in the figure below, all hosts can communicate normally. Is the correspondence between the MAC address and the port in the MAC address table of SWB correct? () (Single-choice question)
- A. MAC-A GO/0/3
MAC-B GO/0/3
MAC-C GO/0/1 - B. MAC-A GO/0/1
MAC-B GO/0/2
MAC-C GO/0/3 - C. MAC-A GO/0/2
MAC-B G0/0/2
MAC-C GO/0/3 - D. MAC-A GO/0/1
MAC-B GO/0/1
MAC-C GO/0/3
Answer: A
NEW QUESTION # 347
As shown in the figure below, the network. All switches enable the STP protocol. Disable SWA's G0/0/2 port to configure the BPDU sending function. SWC's G0/0/1 reconverges to become the root port. Which of the following statements is correct about this process? () (Multiple Choice Questions)
- A. SWA sends configuration BPDU with TC set
- B. SWB forwards TCN BPDU to SWA
- C. SWB sends configuration BPDU with TCA set to SWC
- D. SWC sends TCN BPDU to SWB
Answer: B,C,D
NEW QUESTION # 348
In which working state of the port in the STP protocol can it be changed to the Forwarding state without going through other states? ()
- A. Blocking
- B. Listening
- C. Learning
- D. Disabled
Answer: C
NEW QUESTION # 349
......
The HCIA-Datacom V1.0 certification exam is suitable for a wide range of professionals in the IT industry, such as network administrators, network engineers, and network security professionals. HCIA-Datacom V1.0 certification is also a great option for students who want to gain expertise in data communication technologies as they prepare for their future careers.
Latest H12-811_V1.0 Study Guides 2023 - With Test Engine PDF: https://www.actual4cert.com/H12-811_V1.0-real-questions.html
Easily To Pass New Huawei H12-811_V1.0 Dumps with 701 Questions: https://drive.google.com/open?id=1lwKQ8txPyp3-vV171-KYWJSyvuHtQLaU