Updated Mar 30, 2022 Verified Pass HPE6-A75 Exam in First Attempt Guaranteed
Free HPE6-A75 Sample Questions and 100% Cover Real Exam Questions (Updated 62 Questions)
HP HPE6-A75 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
NEW QUESTION 15
Which protocol do Mobility Controllers (MCs) use to detect a failed Mobility Master (MM)?
- A. SNMP
- B. VRRP
- C. IPSec
- D. PAPI
Answer: A
NEW QUESTION 16
An administrator deploys Aruba Mobility Controller 7005s to a company's branch offices. The administrator wants to disable the console port to prevent unauthorized access to the controllers.
Which controller command should the administrator use to implement this policy?
- A. console disable
- B. mgmt-user console-block
- C. no console enable
- D. no mgmt-user console
Answer: B
NEW QUESTION 17
What is a primary use case for RPVST+ on AOS-Switches?
- A. more granular load balancing than MSTP when access switches connect to two core switches
- B. integration of AOS-Switches in a heterogeneous vendor network that uses the Cisco protocol
- C. enhanced loop protection in an MSTP network
- D. seamless integration with RSTP
Answer: B
NEW QUESTION 18
An administrator implements the MultiZone feature and uses two clusters that utilize CPSec. A primary and a data zone are created. MultiZone APs successfully build sessions to the primary cluster but fail to establish sessions to the data zone cluster.
What must the administrator do to solve this problem?
- A. Enable CPSec in the MultiZone profile for both the primary and data zone.
- B. Use different AP Group names for the two zones.
- C. Add the MultiZone APs to the data zone's CPSec whitelist.
- D. Enable MultiZone booting in the MultiZone AP apboot configuration mode.
Answer: B
NEW QUESTION 19
Refer to the exhibit.
A known unicast packet is received from Switch-1 on the standby and must be forwarded to Switch-2. How does the VSF fabric decide which port in the aggregated (ink should forward the packet?
- A. The standby sends the packet to the commander over a VSF link, and the commander decides the correct port.
- B. The standby selects the port on the designated forwarder for the aggregation.
- C. The standby uses the typical load sharing algorithm, and it might select either its port or the commander's port.
- D. The standby uses its own port in the link aggregation to forward the fabric.
Answer: D
NEW QUESTION 20
An administrator mistakenly configures the wrong VLAN setting on a managed controller's interface. This causes the controller to lose management access to the Mobility Master (MM).
Which mechanism will then attempt to restore the previous working configuration on the managed controller?
- A. bulk configuration
- B. disaster recovery
- C. restore config
- D. auto-rollback
Answer: D
NEW QUESTION 21
Refer to the exhibit.
- A. john
- B. We can't know this from the screenshot above.
- C. mike
- D. Employee
Answer: B
NEW QUESTION 22
What is the purpose of the captive portal URL hash key on an AOS-Switch?
- A. It encrypts and secures the RADIUS messages that the AOS-Switch sends to ClearPass.
- B. It specifies the captive portal URL and conceals the setting in the config.
- C. It does not let users alter the URL that redirects them to the portal.
- D. It authenticates guest users based on the password the users enter hi the portal.
Answer: C
NEW QUESTION 23
An administrator creates service-based policies for AirGroup on the Mobility Master (MM). The administrator can define location-based policy limits based on which information?
- A. AP names, AP groups, controller names, and controller groups
- B. AP names, AP groups, and AP Fully Qualified Location Names (FQLNs)
- C. AP Fully Qualified Location Names (FQLNs) and controller Fully Qualified Domain Names (FQDNs)
- D. Controller names, controller groups, and controller Fully Qualified Domain Names (FQDNs)
Answer: B
NEW QUESTION 24
Which statement is true about the Endpoint Profiler? (Select two.)
- A. Data obtained from the Endpoint Profiler can be used in Enforcement Policy.
- B. The Endpoint Profiler requires the Onboard license to be enabled.
- C. The Endpoint Profiler can only categorize laptops and desktops.
- D. Endpoint Profiler requires a profiling license.
- E. The Endpoint Profiler uses DHCP fingerprinting for device categorization.
Answer: A,E
NEW QUESTION 25
What must an OSPF router do when it receives a link state update?
- A. It must participate in a new election for the Designated Router and Backup DR.
- B. It must run the shortest path first algorithm.
- C. It must re-establish adjacency with its Designated Router and Backup DR.
- D. It must initiate a graceful restart timer.
Answer: B
NEW QUESTION 26
Refer to the exhibit.
An Enforcement Profile has been created in the Policy Manager as shown. Which action will ClearPass take based on this Enforcement Profile?
- A. ClearPass will count down 600 seconds and send a RADIUS CoA message to the NAD to end the user's session after this time is up.
- B. ClearPass will send the Session-Timeout attribute in the RADIUS Access-Request packet to the NAD and the NAD will end the user's session after 600 seconds.
- C. ClearPass will count down 600 seconds and send a RADIUS CoA message to the user to end the user's session after this time is up.
- D. ClearPass will send the Session-Timeout attribute in the RADIUS Access-Accept packet to the NAD and the NAD will end the user's session after 600 seconds.
- E. ClearPass will send the Session-Timeout attribute in the RADIUS Access-Accept packet to the User and the user's session will be terminated after 600 seconds.
Answer: D
NEW QUESTION 27
An administrator wants to use Airwave to manually add devices on the network. Where should the administrator perform this action?
- A. in AMP Setup
- B. in Devices
- C. in Device Setup
- D. in Groups
Answer: C
NEW QUESTION 28
A company requires AOS-Switches at the campus core. The switches:
Will act as the default gateways for several campus VLANs
Must provide redundancy for their services and tolerate the loss of a link or an entire switch Must recover from the failure of one of the switches within a second or less VRRP and MSTP are proposed to meet these requirements. What is an issue with this proposal?
- A. VRRP does not interoperate with MSTP.
- B. VRRP provides redundancy against lost links but not a failed switch.
- C. VRRP provides routing redundancy but not default gateway redundancy.
- D. VRRP takes longer than a second to fail over.
Answer: D
NEW QUESTION 29
An administrator configures the MultiZone feature for a company network, where a mobility cluster is the primary zone and a standalone controller in the company's DMZ represents a secondary data zone. The administrator configures two AP Groups and respective VAPs for the zones on the Mobility Master (MM) in the primary zone. When the APs boot up and establish connections to both zones, the administrator notices that no data connections are established to the data zone.
What must the administrator do to fix this problem?
- A. Configure the same AP Group in the data zone as it is in the primary zone, and configure the VAPs in the data zone.
- B. Configure the same AP Groups and VAPs on the standalone controller, and associate the MultiZone APs to both groups.
- C. Create different AP groups and VAPs on the Mobility Master and standalone controllers, and associate the MultiZone APs to both groups.
- D. Have the MultiZone APs initially boot from the standalone controller in the data zone.
Answer: C
NEW QUESTION 30
A customer wants to implement Virtual IP redundancy, such that in case of a ClearPass server outage, 802.1x authentications will not be interrupted. The administrator has enabled a single Virtual IP address on two ClearPass servers.
Which statements accurately describe next steps? (Select two.)
- A. The NAD should be configured with the primary node IP address for RADIUS authentication on the 802.1x network.
- B. The NAD should be configured with the Virtual IP address for RADIUS authentications on the 802.1x network.
- C. The primary node will respond to authentication requests sent to the Virtual IP address when the primary node is active.
- D. A new Virtual IP address should be created for each NAD.
- E. Both the primary and secondary nodes will respond to authentication requests sent to the Virtual IP address when the primary node is active.
Answer: B,C
NEW QUESTION 31
A network administrator wants to use Aruba AirWave to audit an AOS-Switch configuration. What rs one requirement?
- A. The switch specifies the AirWave IP address for the RADIUS server used for Telnet and SSH authentication.
- B. The switch is authorized in AirWave, which has the correct credentials to log in as a CLI manager.
- C. The switch defines the AirWave IP address in its zero touch provisioning (ZTP) profile.
- D. The switch is set to Manage Read-Write mode in AirWave but is not set to Monitor Only + Firmware Updates.
Answer: A
NEW QUESTION 32
Refer to the exhibit.
A network administrator sets up 802.1X authentication to a RADIUS server on an AOS-Switch. The RADIUS server and user devices are both set up to use REAP MSCHAPv2. The administrator tests the authentication and sees the output shown in the exhibit. Which issue could cause this output?
- A. The administrator entered the wrong password for the test account.
- B. The switch port is set for user mode 801. IX. but the RADIUS server is set for port mode.
- C. The RADIUS shared secret does not match on the switch and the server.
- D. The switch does not have a certificate tor port-access installed on the switch.
Answer: C
NEW QUESTION 33
OSPF is configured on an AOS-Switch, and the network administrator sets the router ID to 10.0.0.1. The administrator wants to be able to reach the switch at this ID from any location throughout the OSPF system. The administrator also needs the router ID to De stable and available, even if some links on the switch fail.
What should the administrator do?
- A. Configure 10.0.0.1 on a loopback interface, and enable OSPF on that interface.
- B. Make sure that 10.0.0.1 is the IP address on the VLAN with the lowest ID.
- C. Configure 10.0.0.1 as a secondary IP address on the switch 00BM poet.
- D. Configure 10.0.0.1 as a manual OSPF neighbor on each switch in the OSPF system.
Answer: A
NEW QUESTION 34
An administrator supports a cluster of four Aruba Mobility Controllers (MCs) with management addresses of 10.1.100.101, 10.1.100.102, 10.1.100.103, and 10.1.202.181. The administrator accesses an AP associated with this cluster, reboots it and accesses apboot mode. The administrator executes the printenv command. Which AP parameter contains the IP addresses of the cluster members that the AP should use to connect to the cluster?
- A. Noodelist
- B. Master_ip
- C. Servername
- D. Cfg_lms
Answer: A
NEW QUESTION 35
......
Download Real HP HPE6-A75 Exam Dumps Test Engine Exam Questions: https://www.actual4cert.com/HPE6-A75-real-questions.html
Verified HPE6-A75 Dumps Q&As - HPE6-A75 Test Engine with Correct Answers: https://drive.google.com/open?id=15oaGXLi_tcBGX7eLMGZ3x9_qW17PYXpH