Verified NCM-MCI5.15 Exam Dumps Q&As - Provide NCM-MCI5.15 with Correct Answers
Pass Your NCM-MCI5.15 Dumps Free Latest Nutanix Practice Tests
NEW QUESTION 16
An administrator is monitoring the Nutanix v5.15-based AOS cluster performance logs and notices that a SQL server VM is greatly exceeding its intended maximum IOPS. The administrator has confirmed that a QoS policy was previously created for the group of VMs this server is a member of.
What are two reasons that this VM would exceed its maximum configured IOPS from the QoS Policy? (Choose two.)
- A. It was cloned from another SQL Server VM that was a member of the QoS Policy.
- B. The SQL Server VM has volume groups attached.
- C. The VM was not created as an AFS virtual machine.
- D. The VM is missing the required snapshot needed to implement the QoS Policy.
Answer: B,C
Explanation:
Ref: https://portal.nutanix.com/page/documents/details?targetId=Prism-Central-Guide-Prism-v5_18:mul-storage-qos-pc-c.html
NEW QUESTION 17
An administrator protected a DB VM running on a Nutanix cluster with NearSync Replication, which schedules to repeat every 15 minutes to a second site. The daily change rate is low. During nightly backups, the replication window is missed due to write volume.
Which two options describe the expected behavior? (Choose two.)
- A. The system continuously tries to get to the NearSync schedule.
- B. Protection Domain transitions back to the hourly schedule.
- C. The Administrator needs to re-enable it manually.
- D. NearSync stops working and fails over to the remote site.
Answer: A,D
NEW QUESTION 18
An administrator has a 32-node hybrid cluster with CPU, RAM and storage utilization of 80%. A database VM is configured with VM Flash.
What is causing this IO latency?
- A. Database VM is experiencing high CPU ready time.
- B. VM Flash Mode reduces SSD tier capacity for VMs.
- C. Curator scans causes by ILM constantly moving data.
- D. Controller VM is experiencing high CPU ready time.
Answer: D
NEW QUESTION 19
An administrator is implementing a VDI solution. The workload will be a series of persistent desktops in a dedicated storage container within a four-node cluster. Storage optimizations should be set on the dedicated storage container to give optimal performance including during a node failure event.
Which storage optimizations should the administrator set to meet the requirements?
- A. Compression, Deduplication, and Erasure Coding
- B. Deduplication and Erasure Coding
- C. Compression only
- D. Compression and Deduplication
Answer: B
Explanation:
Ref:
NEW QUESTION 20
After the migration, some SQL queries take longer to execute than prior to migration.
The following SQL best practices were applied while creating the SQL VM on Nutanix:
* 8 vDisks per SQL server VM
* Database and Log files on separate vDisk
* 2 TempDB database drives and 1 TempDB log drive
What should the administrator to do improve the SQL Server performance?
- A. Create multiple TempDB data files and enable autogrowth
- B. Redistribute existing data by creating additional database files and disable autogrowth
- C. Create multiple SQL log files and disable autogrowth
- D. Redistribute existing data by creating additional database file and enable autogrowth
Answer: D
NEW QUESTION 21
An administrator has an existing Nutanix seven-node cluster running at RF2 that must be changed to have the following capabilities:
* RF3 set for the cluster
* Performance tier deduplication
What is the minimum memory needed on the CVMs to allow for these capabilities?
- A. 32GB
- B. 28GB
- C. 20G?
- D. 24GB
Answer: B
Explanation:
Ref: https://next.nutanix.com/how-it-works-22/rf2-rf3-requirements-37206#:~:text=Controller%20VMs%20must%20be%20configured,for%20the%20feature)%20of%20memory.
NEW QUESTION 22
A customer has a primary datacenter with 12 Nutanix blocks distributed across three racks. The customer wants to achieve the most resiliency possible. They also have a datacenter in a branch office that is 400 kilometers away from the primary datacenter.
Which two solutions should be used? (Choose two.)
- A. Block awareness
- B. Time Stream to a remote site
- C. Async DR to a remote site
- D. Rack awareness
Answer: C,D
NEW QUESTION 23
An administrator manages the following two Nutanix AOS 5.15 cluster environment:
* Corp-cluster-01
* Corp-cluster-02
The VM images must be available only on Corp-cluster-01, but cannot be checked out to cluster Corp-cluster-02. The images also cannot be checked out to any other clusters that are registered with Prism Central in the future.
Which two configuration settings must the administrator choose when creating the image placement policy that satisfies the stated requirements? (Choose two.)
- A. Create an image placement policy that identifies cluster Corp-cluster-01 as the target cluster
- B. Set the policy enforcement to Hard.
- C. Set the policy enforcement to Soft.
- D. Create an image placement policy that identifies cluster Corp-cluster-02 as the target cluster.
Answer: A,B
Explanation:
Ref: https://next.nutanix.com/community-blog-40/nutanix-just-made-ahv-image-management-painless-33144
NEW QUESTION 24
A Nutanix cluster is deployed with the following configuration:
* Three four-node blocks (A, B, and C)
* All Flash Redundancy Factor 2
What is the effect of simultaneous disk failures on two nodes located in block A?
- A. VMs are migrated off of the nodes with disk failures.
- B. VM read and write operations continue normally.
- C. Each node with a failed disk is marked as degraded.
- D. VMs on the nodes with failed disks are unable to write data
Answer: B
Explanation:
Ref: https://next.nutanix.com/how-it-works-22/redundancy-factor-vs-replication-factor-37486
NEW QUESTION 25
A VM is exhibiting one or more of the following baseline values based on the past 30 days:
* CPU usage < 20%
* CPU ready time < 5%
* Memory usage < 50% (moderately) or < 20% (severely)
* Memory swap rate = 0 Kbps
Which type of VM is being described?
- A. Bully VM
- B. Inactive VM
- C. Over-Provisioned VM
- D. Constrained VM
Answer: C
Explanation:
NEW QUESTION 26
An administrator recently added VLAN 205 CRM in Prism Element. The workloads attached to the associated NICs are unable to establish network connectivity.
Which Layer 2 protocol allows the administrator to troubleshoot this issue from Prism Element?
- A. SUP
- B. LACP
- C. LLDP
- D. HDLC
Answer: C
Explanation:
NEW QUESTION 27
An administrator has two clusters: Site A and Site B.
Async DR is configured between the clusters as follows:
* Site A is the Primary Site
* Site B is the Secondary inactive Site, no VMs running
* Site A is fully in Production
* Site B used as Backup/Disaster Recovery
The customer wants to perform a planned failover between the sites.
How should the administrator accomplish this?
- A. Choose Migrate on the Primary site within the Data Protection Dashboard
- B. Click Activate on the Secondary site and run deactive NCLI command on Primary site
- C. Choose Migrate on the Secondary site within the Data Protection Dashboard
- D. Click Activate on the Secondary site within the Data Protection Dashboard
Answer: A
Explanation:
Ref: https://portal.nutanix.com/page/documents/details?targetId=Web-Console-Guide-Prism-v510:wc-protection-domain-failover-wc-t.html
NEW QUESTION 28
An administrator needs to deploy an application with a large amount of data connected via Nutanix Volumes.
Which two actions should the administrator take when designing the Volume Group? (Choose two.)
- A. Use multiple subnets for iSCSI traffic
- B. Enable RSS (Receive Side Scaling)
- C. Distribute workload across multiple virtual disks
- D. Enable thick provisioning on the Volume Group(s)
Answer: B,C
Explanation:
NEW QUESTION 29
A three-node cluster has a Nutanix Files instance with three FSVMs.
What happens after a node failure?
- A. The affected FSVM will be restarted on another node.
- B. The affected FSVM will get live-migrated to another node.
- C. The affected FSVM will not be restarted on another node due to its VM-to-VM anti-affinity settings.
- D. The affected FSVM will not be restarted on another node due to its agent VM setting.
Answer: A
Explanation:
Ref: https://portal.nutanix.com/page/documents/details?targetId=Files-v3_6:fil-files-high-availability-c.html
NEW QUESTION 30
An administrator is trying to correct high cluster IOPs and Cluster Controller Latency. Networking is the suspected issue.
Which networking parameters should be configured in the Nutanix cluster?
- A. Number of NICs connected and frame size
- B. Bond State and network latency
- C. Number of NICs connected and bond state.
- D. Number of NICs connected and network latency.
Answer: A
NEW QUESTION 31
......
Get Top-Rated Nutanix NCM-MCI5.15 Exam Dumps Now: https://www.actual4cert.com/NCM-MCI5.15-real-questions.html