[Dec 29, 2021] 300-510 Ultimate Study Guide - Actual4Cert
Ultimate Guide to Prepare 300-510 Certification Exam for CCNP Service Provider in 2021
NEW QUESTION 57 
Refer to the exhibit. A network operator must stop 10.33.33.33/32 from being redistributed into Level 1 router XR1. Which configuration meets this need?
- A.

- B.

- C.

- D.

Answer: A
Explanation:
Explanation/Reference:
NEW QUESTION 58
Refer to the exhibit
Which router does R1 install as an alternate next hop when trying to reach R3 if LFA is enabled?
- A. R2
- B. R3
- C. R5
- D. R4
Answer: A
NEW QUESTION 59
Refer to the exhibit.
Which task must you perform on interface g1/0/0 to complete the SSM implementation?
- A. configure IGMPv3
- B. enable CDP
- C. disable IGMP
- D. configure OSPFv3
Answer: A
NEW QUESTION 60
Refer to the exhibit.
An engineer has successfully fixed BGP peering issue. R1 has an established eBGP peering with R2 and R3. Which mechanism should the engineer apply in order to steer the traffic correctly?
- A. The weight attribute can be applied on R2 to influence AS 65513 to use AS 65515 as the primary path.
- B. The local preference attribute can be applied on R3 to influence AS 65513 to use AS 65515 as the secondary path.
- C. The MED attribute can be applied on R2 to influence R1 to use it as the primary path.
- D. The IGP metric can be manipulated on R1 to allow traffic to be load balanced between R2 and R3.
Answer: D
NEW QUESTION 61 
Refer to the exhibit. P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other. Which two actions fix the issue? (Choose two.)
- A. Change MD5 to HMAC-MD5
- B. Change MD5 to HMAC-ESP
- C. Remove the send and accept lifetime under key 1
- D. Change MD5 to SHA-1
- E. Change MD5 to HMAC-SHA1-12
Answer: A,E
Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/routers/crs/software/crs_r4-0/security/configuration/guide/ sc40crsbook_chapter5.html
NEW QUESTION 62
Refer to the exhibit.
After troubleshooting BGP traffic steering issue, which action did the network operator take to achieve the correct effect of this configuration?
- A. Routes directly attached to AS 65517 have the local preference set to 150.
- B. Routes that have originated through AS 65517 have the local preference set to 150.
- C. Routes that have passed through AS 65517 have the local preference set to 150.
- D. Routes that have passed through AS 65517 have the local preference set to 150 and the traffic is denied.
Answer: C
NEW QUESTION 63
Refer to the exhibit.
Router 1 has attempted to establish a Cisco MPLS TE tunnel to router 2, but the tunnel has failed. Which statement about this configuration is true?
- A. Router 1 and router 2 must define the RSVP bandwidth reserved on the physical interfaces
- B. Router 1 must define an explicit path to router 2
- C. Router 1 must have Cisco MPLS TE enabled on interface gigabitethernet0/1
- D. Router 2 must have a tunnel interface created with router 1 as the destination
Answer: C
NEW QUESTION 64
An engineer is troubleshooting a connectivity issue across the MPLS network and is verifying the forwarding behavior of packets. Which table does the engineer look at to verify the forwarding behavior of an IP packet as it enters the MPLS network at the ingress LSR?
- A. LFIB
- B. LIB
- C. FIB
- D. RIB
Answer: A
NEW QUESTION 65
Refer to the exhibit.
CE1 and CE2 cannot communicate through the service provider BGP peering is established between PE1 and PE2. IS-IS is the only routing protocol running in the service provider core.
What
step can be done to troubleshoot the issue?
- A. Confirm that IS-IS is running with metric-style narrow.
- B. Switch the IGPs running in the core from IS-IS to OSPF to support a Cisco MPLS TE tunnel from PE1 to PE2.
- C. Configure BGP between CE and PE routers.
- D. Verify the MPLS LSPs.
Answer: A
NEW QUESTION 66
Refer to the exhibit.
A network engineer implemented this segment routing configuration. Which statement about the output is true?
- A. The device must be reloaded for these ranges to be allocated and used.
- B. A nondefault segment routing global block range is being used on this device.
- C. This range conflicts with the segment routing local block range.
- D. The default segment routing global block range is being used on this device.
Answer: B
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/routers/asr920/configuration/guide/segment-routing/ segment-routing-book/seg-routing-global-block.html
NEW QUESTION 67
Which two conditions must be met before separate ISPs can provide interdomain multicast routing? (Choose two.)
- A. Each ISP must replace its RP assignment with a global RP.
- B. Each ISP must support intradomain multicast routing.
- C. Each ISP must dedicate a single router to handle multicast traffic between providers.
- D. Each ISP must configure MSDP to connect its individual multicast administrative domain to the domains at other ISPs.
- E. Each ISP must configure its network to use PIM-DM.
Answer: B,D
NEW QUESTION 68 
Refer to the exhibit. A network engineer implemented this segment routing configuration. Which statement about the output is true?
- A. The device must be reloaded for these ranges to be allocated and used.
- B. A nondefault segment routing global block range is being used on this device.
- C. This range conflicts with the segment routing local block range.
- D. The default segment routing global block range is being used on this device.
Answer: B
Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/routers/asr920/configuration/guide/segment-routing/ segment-routing-book/seg-routing-global-block.html
NEW QUESTION 69
Refer to the exhibit.
An engineer applied the summarization configuration on R1 for four networks (192.168.20.0/24 to 192.168.23.0/24) in area 1 and eight networks (192.168.32.0/24 to 192.168.39.0/24) in area 2 to stop the flooding of all the customer routes. While checking the routing table of R2, the engineer noticed that R1 is still sending only specific routes to R2. Which configuration should the engineer apply on R1 to summarize routes?
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: C
NEW QUESTION 70
Refer to the exhibit.
P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other. Which action fixes the issue?
- A. Change HMAC-MD5 to HMAC-SHA1-12
- B. Configure the send and accept lifetime under key 1
- C. Change HMAC-MD5 to MD5
- D. Change HMAC-MD5 to HMAC-SHA1-20
Answer: B
NEW QUESTION 71
For which reason can two devices fail to establish an OSPF neighbor relationship?
- A. The two devices have different process IDs
- B. The two devices have different router IDs
- C. The two devices have different network types
- D. The two devices have the same area ID
Answer: C
NEW QUESTION 72
Which statement about BFD on Cisco IOS XR Software is true?
- A. BFD is not compatible between Cisco IOS XR and Cisco IOS Software.
- B. Cisco IOS XR router must use LDP to route back to the Cisco IOS router to establish the peer relationship.
- C. Cisco IOS XR router must use dynamic routing or a static route back to the Cisco IOS router to establish the peer relationship.
- D. Cisco IOS XR Software does not support BFD multihop for IPv4.
Answer: C
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r6-3/routing/configuration/ guide/b-routing-cg-asr9000-63x/b-routing-cg-asr9000-63x_chapter_0100.html
NEW QUESTION 73
......
Who should take the Implementing Cisco Service Provider Advanced Routing Solutions (300-510 SPRI) Exam
People who wish to explore the power of the dynamic culture of the Cisco Learning Network to jump-start their certification and lifelong learning goals should take this exam. Those who want to get useful tools for IT training for all Cisco certifications should also get this certification. People with prior knowledge of integrating VPN services, including Layer 2, Layer 3, and IPv6, from the service provider are highly recommended to take this exam and get themselves certified from Cisco.
List of the target audience for this exam:
- Channel partners
- Network supervisors
- Network Operations Center (NOC) personnel
- Network engineers
- Network administrators
- Network managers
- Network designers
- Network architects
CCNP Service Provider Fundamentals-300-510 Exam-Practice-Dumps: https://www.actual4cert.com/300-510-real-questions.html
Use Real 300-510 Dumps - Cisco Correct Answers: https://drive.google.com/open?id=1u-OEAjkArEuZ4HBzmlzIOmoaN4hEM5oe